Replace your faulty slider in less than a minute!

 

Replace your faulty slider in less than a minute!

Instruktionsvideo

 

Remove the old slider

 

Cut off the old slider with a power cutter.
Ensure to get as far in as possible so the power cutter gets a good grip. There are also other possibilities such as cutting off the lower part of the slider or use a screwdriver to bend it off but there is a risk that it will harm the zipper.

 

If ZlideOn is closed

 

In case the ZlideOn is closed you open it holding the bottom part still against a table and pull back the puller until the ZlideOn open up as in the picture above. You can also open the ZlideOn with your fingers in a similar way.

 

ZlideOn lock the zipper

 

If you have a problem with a zipper that opens up by itself you can change the slider to a ZlideOn. A spike on the back side of the puller ensures that the ZlideOn do not slide down when the puller is in above position.

 

Three different ways to attach a ZlideOn

 

In the beginning of a zipper

Put the open ZlideOn the side of the zipper where the stopper is placed.

Click on the ZlideOn by pressing the top and bottom part together with the fingers.

Slip in the other side as usual and close the zipper as normal.

 

In the place where the zipper holds together

Use the place where the zipper still holds together.

Put the open ZlideOn as far in as possible over the place where the zipper holds together

Click on the ZlideOn by pressing the top and bottom part together with the fingers.

 

Crossing the sides of the zipper

If it is not possible to use any of the two other variants to attach the ZlideOn you can cross the sides and put the ZlideOn in the cross

Click on the ZlideOn by pressing the top and bottom part together with the fingers.

Hold the ZlideOn together with the fingers the first 10-20 cm when you close the zipper to ensure it closes properly.